Articles details

  • Agriculture pest and disease risk maps considering MSG satellite data and land surface temperature
  • 01 Jun 2015
  • Pest risk maps for agricultural use are usually constructed from data obtained from in-situ meteorological weather stations, which are relatively sparsely distributed and are often quite expensive to install and difficult to maintain. This leads to the creation of maps with relatively low spatial resolution, which are very much dependent on interpolation methodologies. Considering that agricultural applications typically require a more detailed scale analysis than has traditionally been available, remote sensing technology can offer better monitoring at increasing spatial and temporal resolutions, thereby, improving pest management results and reducing costs. This article uses ground temperature, or land surface temperature (LST), data distributed by EUMETSAT/LSASAF (with a spatial resolution of 3 × 3 km (nadir resolution) and a revisiting time of 15 min) to generate one of the most commonly used parameters in pest modeling and monitoring: “thermal integral over air temperature (accumulated degree-days)”. The results show a clear association between the accumulated LST values over a threshold and the accumulated values computed from meteorological stations over the same threshold (specific to a particular tomato pest). The results are very promising and enable the production of risk maps for agricultural pests with a degree of spatial and temporal detail that is difficult to achieve using in-situ meteorological stations.
  • International Journal of Applied Earth Observation and Geoinformation
  • Elsevier
  • A. M. O. Sousa, Carlos Viegas Damásio, J.R. Marques da Silva, L. Bugalho, L. Pessanha, Paulo Quaresma
  • 38
  • 0303-2434
  • http://www.sciencedirect.com/science/article/pii/S0303243414002918
  • doi:10.1016/j.jag.2014.12.016
  • 40 to 50
  • 1 Jun 2015